Santa Clara Convention Center

 All clothes should be clean, no tears or stains; shirts should be buttoned up, pants pulled up; no open toed shoes.  Show Blacks for Set up, show and strike. Hard Hats during Opera set-up show and strike. High Vis for Symphony pushers.  

Work Clothes: Jeans or other work pants; shorts or sleeveless shirts may not be acceptable in certain circumstances.

Show Blacks: Same as work clothes but black; jeans or cargo pants, small logos are acceptable.

Tech Blacks: Collared shirt (polo or button up), small logos may be acceptable; black jeans or Dockers; black shoes or sneakers.

Dress Blacks: Button up black shirt, no logos; black dockers or dress slacks, polished shoes.

Stage-Technicians

Flashlight
4 in 1 Screwdriver
Crescent Wrench
Multi-tool
Gloves

Rigger’s

Full Body Harness ANSI Z359
Y Lanyard ANSI Z359
80’ Rope 5/8” Single or Double Braid
Sheave
Multi Loop
Carabineers
Plumb Laser
Work Positioning Slings or Grillion
Fall Arrest Slings
Hard Hat with Chin Strap

 Carpenter’s Tool’s

Tool Belt
Tape Measure (30’-35’)
Hammer
4 in 1 Screw Driver
Screw Gun with Phillips Bit, Spare Battery and Charger
Crescent Wrench
Ratchet Wrench – 3/8″ drive, 3/8″, 7/16″, 1/2″, 9/16″ deep sockets
Channel Locks
Pliers
Vise Grips
Diagonal Cutters
Allen Set
Matt Knife
Flashlight
Safety Glasses
Gloves
Pen and Pencil
Black Sharpie

Audio Visual Tools

Flashlight
4 in 1 Screwdriver
Crescent Wrench
Multi-tool
Jewelers Screwdrivers – (Phillips and Flat)
Needle Nose Pliers
Assorted Nut Drivers
Pocket Knife
Circuit Tester
Board Tape or Masking tape
Electrical Tape
Sharpie or other fine point permanent marker
Gloves
Pen and small Pad of Paper

Electrician’s

Tape Measure
4 in 1 Screw Driver
Crescent Wrench
Ratchet Wrench – 3/8″ drive, 3/8″, 7/16″, 1/2″, 9/16″ deep sockets
Channel Locks
Pliers
Wire Cutters
Allen Set
Pocket Knife
Flashlight
Safety Glasses
Gloves
Pen and Pencil
Black Sharpie
OPTIONAL (but highly recommended):
Voltage Meter
Pin Splitter

Electrician’s

Tape Measure
4 in 1 Screw Driver
Crescent Wrench
Ratchet Wrench – 3/8″ drive, 3/8″, 7/16″, 1/2″, 9/16″ deep sockets
Channel Locks
Pliers
Wire Cutters
Allen Set
Pocket Knife
Flashlight
Safety Glasses
Gloves
Pen and Pencil
Black Sharpie
OPTIONAL (but highly recommended):
Voltage Meter
Pin Splitter

 Hard hats: ANZI Z89.1 compliant. Chin straps required for all climbers High Vis: Class 2 or 3 

A Mask is recommended

 Steel toe safety shoes and safety glasses  (if you normally wear glasses are strongly recommended and are the  responsibility of the technician. 

*** Due to the COVID 19 Pandemic, there may be other employer requirements in place for this venue.